Y-cam Bullet Manual de usuario descargar pdf (Pagina 5)

English

Each camera aached will have an internal IP address assigned to it, and displayed. See Fig.2

Select the camera you wish to connect to and click “Open”. This will open up that cameras Homepage in a new

web browser window.

Setup Tips

If no camera details are displayed, wait a few minutes, and then try clicking “Refresh” to search your •

network again.

In your web browsers address bar, there will be an IP address (something similar to hp://192.168.1.100). •

This is the internal IP address of your camera. You can type this IP anyme when connected on the same

network to access your camera.

Depending on your internet setup, the IP address of your camera may change from me to me. If you •

ever need to re-check your IP address, re-run the Y-cam Setup program.

If you are trying to view the Y-cam for the rst me, your browser may prompt you to install or allow •

an “AcveX Control” or to allow or install a QuickTime or Flash control. Click on the bar that appears

at the top of the browser or the pop-up window and click “Install” or “Allow” and follow the on-screen

instrucons. You normally only need to install or allow this control once.

Homepage Live View

From your cameras Homepage, click on “Live View”. See Fig.3

The default username and password is as follows :

Username : admin

Password : 1234

You should now be viewing your camera live.

Camera Sengs Conguraon

In the top right-hand corner of the Live View page, click on “Sengs” and a new set of menus will appear. See

Fig. 4

Click on the word “Wizard” in the top right corner to start the camera setup process. The wizard window will

pop-up. Follow the basic on-screen instrucons.

If you wish to setup WiFi on your camera, you will need to have your wireless key, password and security

encrypon used (if any) that you use to access your WiFi.

With this Wizard, you will be able to setup the:

Name of Camera•

Quality of Picture you wish to view•

Time Zone•

System Time•

WiFi Setup•

TCP/IP Setup•

Most default sengs the camera oers during this wizard will normally be ne for the standard user and

should help you get your camera set-up to a basic level. Once this is completed, close the Wizard and your

web browser, and use Y-cam Setup soware again to search and nd your camera on your network. Now your

camera will be fully operaonal on your local network.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Sin comentarios

Y-cam Bullet Manual de usuario Pagina 5